Our first step in installing a
Whirlbathe whirlpool conversion system is to
determine the wall entry location through which
the hollow parts of the tub can be accessed.
This may be a bedroom, closet, cabinet, hallway,
shower or any interior or exterior wall located
at either end or side of the bathtub. We then
neatly gain access into the wall. Only one
access is needed.
Next, we mark the hydrotherapy
jet locations and drill the holes in the tub.
Utilizing our rigid parallel piping system
patented design and cable system, we pull the
heat-formed rigid pipe arms into place. After
attaching the jets to the tub, the pump is
mounted onto a platform inside the 2x4 wall. The
access opening is then neatly finished off so
that you cannot tell we were in the wall. We
also offer optional standard or spinning jets,
adjustable flow jets and neck jets.
 |
 |
 |
 |
|
Existing Bathtub |
Installing Jets |
Whirlpool Complete |
Ready to Enjoy Spa |
|
