Q. What is a Whirlbathe?
A. A Whirlbathe is a Patented Hydrotherapy
System that uses a water pump and jets to
circulate the water in a bathtub, and converts
any existing bath tub into a whirlpool (Without
Q. How long has Whirlbathe been in business?
A. We have been in the whirlpool bath
conversion business for over 30 years.
Q. Who will install my Whirlbathe?
A. Whirlbathe systems are installed by
certified system installers, who go through an
extensive training with either the Official
Corporate Trainer in Phoenix, or are trained by
each Dealer's Certified System Trainer.
Q. When will I be able to use my new
A. The Whirlbathe system will be tested
immediately upon completion of the conversion
installation. However, to allow all of the
adhesives to fully cure, we ask that you hold
off on taking a full bath for the first 24 hours
after your system is installed.
Q. What type of bathtub do I need to create a
A. Whirlbathe is an extremely versatile
system. It can be added to any conventional
bathtub provided we have accessibility to one
side of the tub. In the past 30 years, there
have only been a very small percentage of tubs
that we could not convert because the
construction of the home prevented us from doing
our job. Unfortunately we cannot do any sunken
tile-lined formed cement tubs because there is
no room behind the surface of the tub.
Q. Can I get tub fittings to match my décor?
A. Yes, in most cases tub fittings can be
matched to your tub color. Fittings are also
available in several metal finishes to match
your bathroom faucets.
Q. Does a Whirlbathe bathtub add
value to my home?
A. Yes! Having a whirlbathe tub is a great
selling feature to prospective buyers, if you're
planning to sell your home in the future.
Q. What are the health benefits of using a
A. A visit to our Medical Benefits page
should answer most if not all of your benefits
questions. Also if you want any professional
opinions on hydrotherapy, Chiropractors and
Doctors know all about the benefits.
Q. How long does it take to install a new
A. In most cases the install takes around 5 hours.
Q. How do I maintain a Whirlbathe bathtub?
A. Maintenance is extremely easy. We suggest
that the system be cleaned once every 1 or 2
weeks using approximately 1 cup of automatic
dishwasher deterget (i.e. Cascade or Finish).
Pour it into the tub while the system is full
and running. If desired, you can also add a cup
of liquid bleach to the water to sanitize the
pipes. Let the system run from 10-20 minutes
with the air volume controls in the Closed/Down
position. Then drain the tub.